VERY IMPORTANT SAFETY NOTES
Please fully read and understand the following notes before commencing with any
work related to the Mk8 MM Flame Safeguard Controller. Failing to do so can
result in serious injury or even death, and can cause serious equipment and
substantial property damage.
Any person working on a boiler must be adequately trained and have a
thorough understanding and appreciation of the boiler plant.
It is the responsibility of the technician working on the plant to ensure that the system
operation meets all local codes and regulations.
Options, Parameters and Expansion Options must only be changed by an Autoflame-trained
and certified technician who has thorough understanding of the Autoflame combustion
control systems and boiler/combustion control in general. Any person changing these
settings without undergoing the necessary training and gaining an understanding of the
boiler plant may place themselves and others in a potentially dangerous situation or cause
permanent equipment damage.
Modification to the Autoflame system settings should only ever be carried out by qualified
combustion engineers. Changes to the Autoflame control system setup has the potential
to make the controller operate in an unstable and potentially unsafe manner.
Commissioning or burner start-up must only be carried out by a an Autoflame- trained and
certified technician.
The commissioning procedure as described must be strictly adhered to. Anybody
commissioning an Autoflame system must be trained in operating combustion equipment
safely.
Autoflame products must only be installed, set up, commissioned and adjusted by an
Autoflame certified technician.
The fundamental idea of the system is to set a fuel valve position and then set a
corresponding air damper position. Care must be taken when adjusting the fuel and air
positions so as not to create any unstable or hazardous combustion conditions, e.g. moving
the fuel valve to the open position without increasing the air damper position. Improper use
may result in property damage, serious physical injury or death.
Electrical connections are live, make sure to fully and safely isolate the mains power before
carrying out any work related to the wiring connections, failure to do so may result in
serious physical injury or death.
If you are unclear about anything related to the Autoflame system, please contact
Autoflame for technical advice.
To Next Page
Loading...
Need help?
General
