Appendix A: Updating Firmware
Page A–5Stellar
®
SR55 Series Soft Starter User Manual – 1st Ed, Rev F – 09/18/2019
9) Once “Update Firmware” and “Confirmation
to Update firmware” has been selected, a
loading bar will appear which shows the
update process has begun.
10) Wait for approximately one minute for the
updating firmware screen to be displayed.
This screen shows the progress of the
firmware being installed on the SR55. There
are three stages of installation.
11) Once the updating process is complete, the
SR55 will reboot. When it has fully rebooted
the status screen will appear.
To Next Page
Loading...
