Automation Direct Stellar SR55 Series - Page 46

Page 3–16 Stellar
®
SR55 Series Soft Starter User Manual – 1st Ed, Rev F – 09/18/2019
Chapter 3: Configuration and Parameters
parameTer deTails – noT Configurable Through TouChsCreen – assoCiaTed WiTh digiTal
inpuTs (ConTinued)
P0.3 – External Trip (Digital Input Control Command Function) Hold. Reg. Type:
Description: Read/Write
Control command for Digital Input: External Trip.
• Ensure start signal is low before reset.
• To map to digital input, refer to P10.2, P10.4, P10.6.
Range: Modbus Decimal Value: Default (decimal):
• Off : The SR55 will not trip.
• On : If “External Trip” is enabled, the SR55 trips.
• 0
• 1
• Off (0)
Modbus Address: Modbus Format:
18880 ( 49C0 hex ) 16-bit unsigned
Touchscreen Menu Path:
none
parameTers assoCiaTed WiTh digiTal ouTpuTs
P0.4 – Ready Hold. Reg. Type:
Description: Read Only
STATUS INDICATION : Ready
• To map to Digital Output, refer to P11.0, P11.2, P11.4, P11.6.
Range: Modbus Decimal Value: Default (decimal):
• Off : The SR55 has not powered up successfully, or failed to
reset from a trip.
• On : Indicates that the SR55 is healthy and ready for a start.
Remains on when Running.
• 0
• 1
• Off (0)
Modbus Address: Modbus Format:
37184 ( 9140 hex ) 16-bit unsigned
Touchscreen Menu Path:
none
P0.5 – Enabled Hold. Reg. Type:
Description: Read Only
STATUS INDICATION : Enabled
• To map to Digital Output, refer to P11.0, P11.2, P11.4, P11.6.
Range: Modbus Decimal Value: Default (decimal):
• Off : The SR55 has not powered up successfully, or failed to
reset from a trip.
• On : Indicates that the SR55 is enabled and ready for a start.
Remains on when Running.
• 0
• 1
• Off (0)
Modbus Address: Modbus Format:
37248 ( 9180 hex ) 16-bit unsigned
Touchscreen Menu Path:
none