117
4
Icon assigns available logical (relay) outputs to a subscenario. Having added a logical output, the following
windows are to be lled:
Component – select an output card or reman microphone, a communications card containing the output we want to use.
Output – select from the list of available outputs on the device, from the Component tab, the output which we want to control.
State – allows to determine the nal state of the relay contacts following activation. Active results in changing the relay state
to the opposite one on execution of a scenario. For Inactive, the relay does not change its state when the scenario is activated.
NC/ Normal (Inverse) – informs of the initial state of a relay before activation of the function. If we set Active in the State,
thenactivation of the scenario for an NC/Normal relay causes transition into NO – Normally Open. It must be remembered
that after the Duration time has expired, as counted from activation of a given scenario, the assigned logical outputs remain
in the state as dened in the subscenario. They do not return to the default settings.
By marking the Toggle option causes that each time when the output assigned to a scenario is activated, then the relay state
changes into the opposite to the one which was set at an earlier activation. The default state at the rst activation depends
of the State eld settings.
5
Add Custom Action – an editor window in which one’s own system function can be written in the LUA scripting language.
6
Subscenario cloning function: Clone Subscenario – this is available under the icon . A single click of the left mouse
button on the icon creates a new subscenario of the identical composition as the one created before.
7
Up / Down arrows – enable to change the order in which scenarios are executed. The order of subscenario execution
by the system is top to bottom according to the times, as declared in the Duration window.
To Next Page
Loading...