To Next Page

To Previous Page

Activating warning message in selected re zones

» Open red “Evacuation” button ap and press it. At this moment VASCU will switch into alarm mode. Next, choose zones you

wish to send the message to.

» Green LEDs corresponding with selected zones will light up on the microphone.

» Press “Warning” button. To deactivate the message, press “Clear” button.

» To return to normal mode, press “cancel alarm” button.

Activating warning message in all zones

Open red “Evacuation” button ap and press it or press once the red button on the front panel of AutroVoice miniVES

and within 5 seconds press the button once again. At this moment VASCU will switch into alarm mode. Next, press

the “all zones” button.

Green LEDs corresponding with all of the zones will light up together with the LED next to the “all zones”

button on the microphone.

» Press “warning” button. To deactivate the message, press “clear” button.

» To return to normal mode, press “cancel alarm” button.

Activating evacuation message in selected re zones

» Open red “Evacuation” button ap and press it or press once the red button on the front panel of AutroVoice miniVES and

within 5seconds press the button once again. At this moment VASCU will switch into alarm mode.

Press selected zones buttons. You can choose more than one zone. Green LEDs corresponding with selected zones will light up.

» Press “Evacuation” button. To deactivate the message, press “clear” button.

» To return to normal mode, press “cancel alarm” button.

Activating evacuation message in all zones

Open red “Evacuation” button ap and press it or press once the red button on the front panel of AutroVoice miniVES

and within 5 seconds press the button once again. At this moment VASCU will switch into alarm mode. Next, press

the “all zones” button.

Green LEDs corresponding with all of the zones will light up together with the LED next to the “all zones” button on

the microphone.

» Press “Evacuation” button. To deactivate the message, press “clear” button.

» To return to normal mode, press “cancel alarm” button.

Mute

» In alarm mode it is possible to mute warning and/or evacuation messages. To do so, choose zone and press “mute” button.

The messages will not be audible in this location.

» You can choose all zones and press “mute”. Then, messages for the entire system will be muted.

Remember that alarm mode is active all the time – (the LED next to the ALARM symbol on the microphone chassis is on),

contacts, controls and settings assigned to the alarm scenario are maintained. Muting operation is recorded in the event log.

» Choose zone and activate warning or evacuation action to send messages again.

» To return to normal mode, press “cancel alarm” button.

Autronica AutroVoice miniVES Series User Manual

Questions and Answers: