Autronica BS-420 - Reboot System

Service Commands
Operator's Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-OPERATE/FGB Rev.G, 2016-02-19,
Autronica Fire and Security AS
Page 138
14.7.6 Reboot System
This menu allows you to reboot all panels in the entire system. This
command has to be run after an upgrade of the system.
Note that in Dual Safety systems, only panels belonging to either the
Primary or Secondary system will be rebooted, depending on which
system the panel in question belongs to.
Step Actions to be taken Display Indication
1
To enter the Main Menu, press the Menu button
2
To select SERVICE, press 5.
3
To select UPGRADE, press 5.
4
To select REBOOT SYSTEM, press 6.
MENU
19:
23
Total: 3
1 SHOW STATUS
2 DISABLE
3 ENABLE
4 SYSTEM
5 SERVICE
SERVICE
19:23
1 TEST
2 LOG
3 LOOP COMMANDS
4 REPORT
5 UPGRADE
6 REMOTE ACCESS
7 DUAL SAFETY
8 OIL & GAS COMMANDS
SERVICE
1 UPGRADE SW
2 UPGRADE CONFIG
3 EXPORT CONFIG
4 EXPORT LOG
5 VIEW UPGRADE STATUS
6 REBOOT SYSTEM
19:23
UPGRADE