Autronica BS-420 - Example - How to Disable Detection Zones

Menu Mode
Operator's Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-OPERATE/FGB Rev.G, 2016-02-19,
Autronica Fire and Security AS
Page 62
9.5 How to Operate in Menu Mode
All menu selections represent a digit. To enter a menu selection, you
simply have to press the corresponding digit. Then you can either;
 use the keyboard to enter text into an input field
or
 press the ENTER button and use the up/down arrows to move the
cursor to the desired selection.
9.6 Example - How to Disable Detection Zones
 From the top level of the Menu, press, for example, digit 2 to select
DISABLE
 Press digit 1 to select DETECTION ZONES.
 Now, you can either;
a) Use the keyboard to enter text into the input field.
or
b) Press the ENTER button, then use the up/down arrows to
move the cursor to the desired selection in the selection field.
 Refer to the two subsequent chapters.
MENU
19:23
Total: 3
1 SHOW STATUS
2 DISABLE
3 ENABLE
4 SYSTEM
5 SERVICE
MENU
19:23
Total: 3
1 SHOW STATUS
2 DISABLE
3 ENABLE
4 SYSTEM
5 SERVICE
DISABLE
19:23
Total: 3
1 DETECTION ZONES
2 POINTS
3 FIRE ALARM DEVICES
4 FIRE ALARM ROUTING EQUIPMENT
5 OUTPUTS
6 FAULT WARNING ROUTING EQUIPMENT
7 IMMEDIATE OUTPUT ACTIONING
DISABLE
19:23
Total: 3
1 DETECTION ZONES
2 POINTS
3 FIRE ALARM DEVICES
4 FIRE ALARM ROUTING EQUIPMENT
5 OUTPUTS
6 FAULT WARNING ROUTING EQUIPMENT
7 IMMEDIATE OUTPUT ACTIONING