Autronica BS-420 - Show Status - Detection Zones in Test

Show Status
Operator's Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-OPERATE/FGB Rev.G, 2016-02-19,
Autronica Fire and Security AS
Page 71
10.7 Show Status - Detection Zones in Test
This menu gives detailed information on the zones in test mode.
The example below describes how to view the current status of zones
in test mode.
Step Actions to be taken Display Indication
1
To enter the Main Menu, press the Menu button
2
To select SHOW STATUS, press 1.
3
To select DETECTION ZONES IN TEST, press
5.
4
To move the cursor to the desired selection,
scroll with the arrow buttons
5
To view detailed zonal information for the
selected detection zone, press
6
To view point(s) in test for the selected detection
zone, press Action Digit 1 (SHOW POINTS).
7
To return (each step backwards), press the
Close Window button
MENU
19:23
Total: 3
1 SHOW STATUS
2 DISABLE
3 ENABLE
4 SYSTEM
5 SERVICE
SHOW STATUS
1 FIRE ALARMS
2 FIRE WARNINGS
3 FAULTS
4 DISABLEMENTS
5 DETECTION ZONES IN TEST
6 ACTIVATED OUTPUTS
7 ACTIVE SENSORS
8 OIL&GAS INHIBITED POINTS
19:23