Autronica BS-420 User Manual

Service Commands
Operator's Handbook, AutroSafe Interactive Fire Detection System, Release 4, 116-P-ASAFE-OPERATE/FGB Rev.G, 2016-02-19,
Autronica Fire and Security AS
Page 141
Step Actions to be taken Display Indication
4
To transfer the loop control to the Secondary
System, press 2, then
or
to transfer the loop control to the Primary
System, press 1, then .
Dual Safety Stdby
Applicable to systems using the Dual Safety concept; a system with
redundant loop control consisting of a Primary and Secondary System.
 Steady yellow light:
The panel is in Standby Mode, i.e. this panel does not control the
detection loops. The panel(s) in the other system controls the detection
loops and is in Active Mode.
 Blinking light: the panel does not control all detection loops/loop units,
and/or loop control is being transferred. Actions must be taken.

Autronica BS-420 Specifications

General

Brand	Autronica
Model	BS-420
Category	Fire Alarms
Language	English