Avaya 9608 - Call Tracing and Recording

Administering options for the 9608, 9611G, 9621G, and 9641G SIP Deskphones
Issue 1 May 2011 87
DISPLAY_NAME_
NUMBER
0 Indicates whether the calling party’s number will
be displayed next to the caller name on an
incoming call. If this parameter is not set, only the
caller name is shown. Valid values are:
1 = Show caller’s name and number.
0 = Show caller’s name only.
DNSSRVR 0.0.0.0 Text string containing the IP Address of zero or
more DNS servers, in dotted-decimal format,
separated by commas with no intervening spaces
(0-255 ASCII characters, including commas).
DOMAIN " " (Null) Text string containing the domain name to be used
when DNS names in parameter values are
resolved into IP Addresses. Valid values are 0-255
ASCII characters.
DOT1X 0 Defines the deskphone's operational mode for
IEEE 802.1X.Valid values are:
0 = Unicast Supplicant operation only, with PAE
multicast pass-through, but without proxy Logoff.
1= Unicast Supplicant operation only, with PAE
multicast pass-through and proxy Logoff.
2= Unicast or multicast Supplicant operation,
without PAE multicast pass-through or proxy
Logoff.
DOT1XEAPS MD5 Specifies the EAP authentication method(s) to be
used with IEEE 802.1X. Comma-separated list of
key words defining EAP methods. In SIP Release
2.0, this value is restricted to a single EAP method.
Valid values are either "MD5" or "TLS".
DOT1XSTAT 0 IEEE 802.1X status. Enables/disables IEEE
802.1X function and, if enabled, additionally
defines reaction on received multicast or unicast
EAPOL messages. Valid values are:
0 = Supplicant operation disabled.
1 = Supplicant operation enabled, but responds
only to received unicast EAPOL messages.
2 = Supplicant operation enabled, responds to
received unicast and multicast EAPOL messages.
DSCPAUD 46 Differentiated Services Code Point for audio.
Values range from 0 to 63.
DSCPSIG 34 Differentiated Services Code Point for signaling.
Values range from 0 to 63.
DSTOFFSET 1 Used for daylight saving time calculation in hours.
Values range from 0 to 2.
Parameter Name Default
Value
Description and Value Range
5 of 30