information on entry and validation of addresses in either
format, see Entering and validating IPv4 and IPv6
addresses on page 41. For example, to enter the IP
address 111.222.333.444 in IPv4 format, press the
number 1 on the dial pad three times then press *, press
the number 2 on the dial pad three times then press *,
press the 3 on the dial pad three times then press *, then
press the 4 on the dial pad three times.
To enter an IP address in IPv6 format, use the dial pad
in numeric-only mode entry. Tap the desired dial pad key
once for touch screen phones, except for 2 and 3 which
are alphanumeric. Use multi-tap for touch screen
phones. For example, pressing button 2 initially enters a
2, followed by A, B, C, and back to 2. Pressing button 3
initially enters a 3, followed by D, E, F, and back to 3.
Proceed to the next step.
To change the 802.1Q
value
Use the Right navigation arrow to navigate through the
text strings corresponding to the L2Q values defined as
Auto if L2Q=0, On if L2Q=1, and Off if L2Q= 2 until the
text string of the value you want to change to displays.
Proceed to the next step.
To change the VLAN
ID value
Use the dial pad to enter the new static VLAN ID of from
0 to 4094, inclusive. Proceed to the next step.
To change the
VLANTEST value
Use the dial pad to enter the new value of the
DHCPOFFER wait period of from 0 to 999. Proceed to
the next step.
4. Press Save to store the new setting and redisplay the Craft Procedures screen or
Cancel to return to theCraft Procedures screen without saving the value entered.
Once the new values are stored, the phone resets automatically.
Calibrating the touch screen
About this task
Use screen calibration for proper alignment of the touch screen if a significant problem with
the touch screen arises.
Important:
Use a stylus instead of your finger to touch the calibration points precisely.
Note:
The CLEAR Craft procedure clears any calibration data set using the CALIBRATE SCREEN
Craft procedure, but does not change factory settings of calibration data. Use the Default
Calibrating the touch screen
Installing and maintaining Avaya IP Deskphone H.323 9608, 9608G, 9611G, 9621G, and 9641GJanuary 2014 49
To Next Page
Loading...
