Changing the group identifier
About this task
Note:
When updating Craft procedures from a touch screen deskphone, touching the line you want
to change or the applicable softkey produces the same result as selecting a line and pressing
the applicable softkey on a non-touch screen IP deskphone.
Use the following procedure to set or change the group identifier.
Note:
Perform this procedure only if the LAN Administrator instructs you to do so. For more
information about groups, see
Applying settings to logical groups on page 69.
Procedure
1. When you select GROUP from the Craft Procedures screen, the following text
displays:
Current Setting:
New Setting:
where the setting is the current system value of NVGROUP.
2. In the Group text box, enter a valid Group value from 0 to 999.
3. Press Save to store the new setting. The deskphone displays the Craft Procedures
screen.
Setting handset audio equalization
About this task
Note:
Use the following procedure to set or change the handset audio equalization value.
Procedure
1. When you select HSEQUAL from the Craft Procedures screen, the following
displays:
Changing the group identifier
Installing and maintaining Avaya IP Deskphone H.323 9608, 9608G, 9611G, 9621G, and 9641GJanuary 2014 55
To Next Page
Loading...
