• Current Setting:
• New Setting:
Where the Current Setting is the current value of HSEQUALIZATION, an internal
parameter that combines the audio equalization specifications of the settings file,
user option, and Local Procedure.
The values are Default TIA-810/920 and S004 is used, Audio Opt TIA-810/920 and
S004 is used, or HAC Opt HAC is used. The only difference between Default and
Audio Opt is that in the second case, either the settings file, the user option, or the
Local Procedure has explicitly selected TIA-810/920 and S004.
2. Press Save to store the new setting and redisplay the Craft Procedures screen.
Changing Ethernet interface control
About this task
Note:
When updating Craft Procedures from a touch screen phone, tapping the line you want to
change or the applicable softkey produces the same result as selecting a line and pressing
the applicable softkey on a non-touch screen IP phone.
Use the following procedure to set or change the interface control value.
Procedure
1. When you select INT from the Craft Procedures screen, the phone displays the
following options with a prompt to use the Right and Left navigation arrows to select
a setting:
Ethernet Choice Selector
PC Ethernet Choice Selector
The options that are displayed are the text strings associated with the current
PHY1STAT on the Ethernet line and the current PHY2STAT system value on the
PC Ethernet line.
• Auto when PHY1STAT = 1
• 10 Mbps half when PHY1STAT = 2
• 10 Mbps full when PHY1STAT = 3
• 100 Mbps half when PHY1STAT = 4
Using local Administrative Menu procedures
56 Installing and maintaining Avaya IP Deskphone H.323 9608, 9608G, 9611G, 9621G, and 9641GJanuary 2014
Comments? infodev@avaya.com
To Next Page
Loading...
