Related links
Display Controls on page 143
Display Contrast
On the J169 phone, you can change the display contrast. If the phone also has any button
module's attached, you can separated adjust the contrast of the display on each module.
Procedure
1.
Press the
button.
2. Use the cursor keys to select Settings.
3. Use the cursor keys to select Display.
4. Use the cursor keys to select Contrast.
5. Use the left/right cursor keys to adjust the contrast as required.
6. If your phone has button modules, scroll up or down to select the module for which you
want to adjust the contrast.
7. When completed, press Save.
8. Press Back/Exit to exit the menus.
Related links
Display Controls on page 143
Single/Dual Column Display
The phone can be set to use either the full screen width (single-column mode) or just a half-width
(dual-column mode) for each programmable appearance and feature button. The number of
programmable buttons that can be configured is not affected by the selected display mode.
Your system administrator can select which option is used by default. However, you can then
select which one you prefer.
In the J159 phone, this setting only affects the primary screen.
Procedure
1. Press the Features soft key if shown.
• To do this during a call, press the PHONE key and then press Features.
2. Use the cursor keys to select Phone User.
3. Use the cursor keys to select Phone Screen Settings.
Display Controls
April 2020 J100 Series Phone User Guide 144
Comments on this document? infodev@avaya.com
To Next Page
Loading...
Need help?
General
