Avaya JEM24 User Manual

level. The settings are done in both 46xxsettings.txt file and System Manager. The order of
precedence is as follows:
• Phone through Administration menu settings
• Web user interface
• Avaya Aura
®
System Manager
• Settings File
• DHCP
• LLDP
If you log in with your extension on MDA2 during a call and the signaling address mode is different
from that of MDA1, then a limited service icon momentarily displays on MDA2. MDA2
automatically switches its signalling address family to match MDA1.
Parameter Description
SIP_CONTROLLER_LIST_2 Describes the list of SIP Proxy or Registrar servers
separated by comma when the SIP device is
configured for the dual-stack operation.
Valid values are 0 to 255 characters in the dotted
decimal or colon-hex format.
The syntax is:
host[:port][;transport=xxx]
where
• host is IP addresses in dotted-decimal format or
hex format.
• [:port] is the port number. The default values
are 5060 for TCP and 5061 for TLS.
• [;transport=xxx] is the transport type and
xxx is either TLS or TCP. The default value is
TLS.
For example,
SIP_CONTROLLER_LIST_2="10.16.26.88:506
0;transport=tcp"
SIGNALING_ADDR_MODE Describes the SIP registration over IPv4 or IPv6
and selects the preferred Avaya Aura
®
Session
Manager for phones supporting the dual-stack
mode. The Avaya Aura
®
Session Manager IP
address is selected according to the parameter
SIP_CONTROLLER_LIST_2.
Valid values are:
• 4: IPv4. This is the default value.
• 6: IPv6
Feature and application configuration
July 2019 Installing and Administering Avaya J100 Series IP Phones 168
Comments on this document? infodev@avaya.com

Avaya JEM24 Specifications

General

Brand	Avaya
Model	JEM24
Category	IP Phone
Language	English