Avaya JEM24 - Page 233

Parameter name Default
value
Description
CONF_TRANS_ON_PRIMARY_APPR 0 Determines conference and
transfer setup whether to use idle
primary call appearance or idle
bridged call appearance.
Value operation:
• 0: To specify conference and
transfer setup to use an idle
primary call appearance at first
attempt. However, if an idle
primary call appearance is
unavailable, then the setup will
use idle bridged call appearance
regardless of the setting of
AUTO_SELECT_ANY_IDLE_AP
PR. If a bridged call appearance
initiates the setup, then setup will
use idle bridged call appearance
of same extension. If an idle
bridged call appearance of the
same extension is not available
and
AUTO_SELECT_ANY_IDLE_AP
PR is set to 1, then setup will use
any idle call appearance.
However, if
AUTO_SELECT_ANY_IDLE_AP
PR is set to 0 and if same bidged
call extension is not available, the
setup initiated on a bridged call
appearance will be denied.
• 1: To specify conference and
transfer setup to use an idle
primary call appearance at first
attempt. However, if an idle
primary call appearance is
unavailable, then the setup will
use idle bridged call appearance.
If a bridged call appearance
initiates the setup, then setup will
use idle bridged call appearance
of either the same extension or
different extension.
AUTO_SELECT_ANY_IDLE_AP
PR is ignored.
Table continues…
List of configuration parameters
July 2019 Installing and Administering Avaya J100 Series IP Phones 233
Comments on this document? infodev@avaya.com