Parameter name Default value Description
VLANTEST 60 Specifies the number of seconds that the phone
waits prior to failing back to a different VLAN ID if
no response is received from the DHCP server.
Valid values are 0 through 999.
Value operation:
• 0: The phone continues to attempt a DHCP
REQUEST forever.
VLANTEST is configured through:
• Settings file
• A name equal to value pair in DHCPACK
message
VLANSEP 1 Specifies whether the VLAN separation is
enabled or disabled by the built-in Ethernet
switch.
Value operation:
• 0: Disabled
• 1: Enabled
VLANSEPMODE 1 Specifies whether the VLAN separation is
enabled or disabled.
Value operation:
• 0: Disabled
• 1: Enabled
VLANSEPMODE is configured through the
Settings file.
PHY2TAGS 0 Determines whether or not VLAN tags are
stripped on Ethernet frames going out of the
Computer (PC) port.
Value operation:
• 0: Strip tags. VLAN tags are stripped from
Ethernet frames leaving the computer (PC)
port of the phone.
• 1: Does not strip tags. VLAN tags are not
stripped from Ethernet frames leaving the
Computer (PC) port of the phone.
PHY2TAGS is configured through the Settings
file.
Table continues…
Virtual LAN (VLAN)
July 2019 Installing and Administering Avaya J100 Series IP Phones 59
Comments on this document? infodev@avaya.com
To Next Page
Loading...
