Avaya XT Series XT5000 Series XT4000 Series

To Next Page

To Previous Page

Before you begin

Access the quick setup wizard from the endpoint or web interface, as described in

Configuring

Basic Settings with the Quick Setup Wizard on page 34.

Procedure

1. Define the name and language.

2. To adjust the image on your monitor, select Next and continue with Adjusting the Image

Position on page 36.

If performing the quick setup from the web interface, access the quick setup from the

endpoint to adjust the image. This can be done at any time.

Related links

Configuring Basic Settings with the Quick Setup Wizard on page 34

Adjusting the Image Position

About this task

You can center the endpoint's image correctly on its monitor in this stage of the Quick Setup

Wizard.

This is for deployments with a monitor connected to your Avaya XT Series.

Procedure

1. Access the Quick Setup Wizard from the endpoint, as described in

Configuring Basic

Settings with the Quick Setup Wizard on page 34.

2. Decide if the monitor's image needs adjusting, by verifying if the white border of the

triangles in the top left and bottom right corners are fully visible on all sides.

If the image is centered correctly, skip this procedure and select Next.

3. Press 1 to highlight the triangle in the top left corner in blue.

4. Use the arrow keys to position the image, so all sides of the white border of the triangle are

visible in the screen, then press ok/menu.

5. Press 2 to highlight the triangle in the bottom right corner in blue.

6. Adjust the image position in the same way, until all sides of the triangle border are visible,

then press ok/menu.

7. To continue with the Quick Setup Wizard, select Next (see

Configuring Basic Network

Settings on page 37).

If your monitor is 4K and your system is an Avaya XT7000 Series, graphic adjustment is

not applied.

Avaya XT Series XT5000 Series XT4000 Series - Page 36