What to do if after downloading a script, the script does not appear to be loaded on Avery Dennison Barcode Reader?
If, after downloading a script to your Avery Dennison Barcode Reader, the script does not appear to be loaded, try formatting the flash memory and then downloading the script again.
What to do if Avery Dennison Barcode Reader errors when downloading a script?
If your Avery Dennison Barcode Reader encounters an error when downloading a script, check the available flash memory. You may need to format the flash memory or clear NVRAM.
What to do if Avery Dennison Barcode Reader prints blank labels or 750 series errors?
If your Avery Dennison Barcode Reader is printing blank labels or showing 750 series errors, clean the supply sensors.
What to do if Avery Dennison Barcode Reader backing paper is wrapped around platen or peel roller?
If the backing paper is wrapped around the platen or peel roller of your Avery Dennison Barcode Reader, carefully remove the backing paper. When using backfeed and peel mode, make sure the backing paper tears at the saw-toothed tear edge.
What to do if Avery Dennison Barcode Reader does not feed?
If your Avery Dennison Barcode Reader is not feeding, ensure the wide/narrow knobs are set correctly.
How to fix Avery Dennison Barcode Reader error message during startup?
To address an error message appearing during the startup of your Avery Dennison Barcode Reader, turn off the printer, wait fifteen seconds, and then turn it back on. If the error message reappears, contact Technical Support.
What to do if Avery Dennison Barcode Reader prints partially printed data?
If your Avery Dennison Barcode Reader is only printing partial data, clean the printhead and send a corrected format packet.
What to do if Avery Dennison Barcode Reader has voids in printing?
If you notice voids in the printing of your Avery Dennison Barcode Reader, try cleaning the printhead, changing the supply type, and checking the ribbon.
General| Operating Temperature | 41°F to 104°F (5°C to 40°C) |
|---|---|
| Storage Temperature | -4°F to 140°F (-20°C to 60°C) |
| Print Resolution | 203 dpi |
| Connectivity | Ethernet, USB, Serial |
| Media Types Supported | Labels, Tags |
| Operating System Compatibility | Windows |
| Power Requirements | 100-240 VAC, 50/60 Hz |
| Humidity | 20% to 85% non-condensing |
To Next Page