E1070 Service Manual 55
3.4 Service Menu
Port 1 or Port 2
1. With SEriAL displayed, press the PRINT key…
Port 1 is displayed.
2. Scroll through the other choices, Port 2 and String, by using the TARE or
UNITS key and press the ENTER key to accept the displayed choice. If you
choose Port 1 or Port 2, continue with the rest of this step. If you choose
String, go to STRING (Custom print formats) on page 64.
All the port configuration items are identical for Port 1 and Port 2 except
port 1 has two additional TYPE selections (RS-485 and 485HD). Use the
following steps to configure each port.
bAud is displayed. Use this item to set the baud rate.
BAUD (Baud rate)
1. With bAud displayed, press the PRINT key …
Current baud rate is displayed. Choices are from 300 to 115,200.
Default is 9600.
2. Scroll the choices by using the TARE or UNITS key and press the ENTER key
to accept the displayed choice. .
bAud is displayed.
D-BITS (Data Bits)
3. With bAud displayed, press the UNITS key…
d-bitS is displayed. Use this item to set the data bits value.
4. Press the PRINT key…
7 or 8 is displayed.
5. Toggle between the choices by using the TARE or UNITS key and press the
ENTER key to accept the displayed choice. .
d-bitS is displayed.
PARITY (Parity setting)
1. With d-bitS displayed, press the UNITS key…
PAritY is displayed. Use this item to set parity.
2. Press the PRINT key…
nonE, Odd or EvEn is displayed.
3. Scroll through the choices by using the TARE or UNITS key and press the
ENTER key to accept the displayed choice. .
PAritY is displayed.