99
Model E1070 Indicator Service Manual
27. Press the PRINT key. . .
PRINT is displayed.
28. Press the PRINT key to print the report.
Port 1 or PORT 2 is displayed. Use this item to select which port
to use for printing the report.
29. Toggle between PORT 1 and PORT 2 using the TARE or UNITS key.
Press the ENTER key when the choice you want is displayed. . .
Display shows BUSY briefly then returns to PRINT.
30. Press the UNITS key. . .
CLEAR is displayed. Use this to clear the log from memory.
31. Press PRINT to clear the log. . .
SURE? is displayed.
32. Press ENTER to clear the log. . .
CLEAR is displayed.
33. Press the SELECT key. .
GHOST is displayed.
34 Repeatedly press the SELECT key until. . .
SETUP is displayed.
This completes the Setup submenu of the Supervisor menu. You
can return to normal operation (step 26) or go to the next sub-
menu item, TEST, by pressing the UNITS key.
35. Press the ESC key to return to normal weighing mode. You will be
prompted to save the changes you’ve made. Press the ESC key to abort
any changes made or press ENTER to accept them and return to
normal operating mode.
Supervisor Menu—(continued)
To Next Page
Loading...
