Avidsen ORANE-CONNECT - Page 33

EN33EN 32
• HomeGate connected module
+
-
BATTRANS
GND GND PHO +24V M1- M2- M1+ M2+ warn- warn+ 2B
AC
IN
230V AC
L
N
Install the magnet enabling gate state feedback from the application.
• Put the gate in closed position
• Install the pre-wired magnet on the panel on the side of the electronic card. Install the passive magnet on
the other panel, leaving a gap of no more than 13mm. The magnets must not touch.
Passive magnet
Grommet
.
Electronic
card
Contactor
Pre-wired
magnet
C - INSTALLATION