EN51EN 50
E - USE
To complete your registration, set a password
between 6 and 20 characters long with letters and
numbers only. then press Terminé (Finished).
7.2 - Connecting the contactor
As soon as it is switched on, the contactor will be in
pairing mode by default. The indicator light will then
flash until the pairing procedure is completed.
To start the pairing, press AJOUTER (ADD). Make
sure your phone is
connected on the 2.4GHz WiFi network of your
router. If you already have a device installed on the
application (e.g. IP camera, smart plug, etc.) click on
+ in the top right corner of the application.
Select the product you wish to pair and select Home
Gate.
Make sure the contactor is connected and its
indicator light is flashing. If not, press and hold
the reset button for 5s so that the indicator starts
flashing. Select your 2.4GHz WiFi network (note:
your smartphone must be connected to the WiFi
network to which the plug will be connected), enter
your network password and press suivant (next).
IMPORTANT: if a location authorisation request
message appears, you need to accept it for your
Android or iOS device to receive your WiFi.
IMPORTANT: This device is compatible with 2.4
GHz - WPA/WPA2 networks. Not compatible
with 5 GHz WiFi
or with WEP encryption. Please check the WiFi
settings of your router or contact your Internet
service provider if you experience connection
difficulties.
To Next Page
Loading...
