Avigilon ALTA - Entry States and Schedules

l
Port—selecttheportfortheWiegandDevicetowhichthisentryiswired.
l
Mode—selecttheModetosetwhichdirectionthecardcredentialdataissent:

o
UseInputtoreceivedatafromdevicessuchasaWiegandreader.

o
UseOutput(Gateway)tosendcredentialdatatoathird—partycontrolpanel.SeeAppendixA:
ConfigureAvigilonAltaControlCenterwithlegacysystemsonpage143formoreinformation.
Addadditionalcontrols
l
Ifanentryhasmorethanoneofanycontrols(OpenpathReaders,Entry/ExitHardware,ContactSensor,
RequesttoExit,orWiegandDevice)installed,youcanselectwhichadditionalcontrol(s)youwouldlike
toassociatewiththeentry.
l
Onceyouaddanadditionalcontrol,itwillappearintherelevantsectiononthispage.
Figure9AdditionalControls
Entry states
AnEntryStatedefineswhetheranentryisunlockedandwhataccessmethodsmaybeusedtounlockit.
AvigilonAltaControlCenterprovidesthefollowingdefaultentrystates:
l
Unlocked—Nocredentialisrequiredforaccess.
l
NoEntry—Noentryallowed,evenwithanotherwisevalidcredential.
l
Lockdown-OverrideOnly—Noentryallowed,evenwithanotherwisevalidcredential,exceptfor
overrideunlockrequests.
l
Convenience—Allowsallvalidcredentialsandtriggermethods.
l
OnsiteOnly—Allowsallvalidonsitecredentialsandtriggermethods.
l
StandardSecurity—Allowsmostmobileaccessandcards,andexcludesremotemobile1FAandthird-
partyWiegandmethods.
Sites 62