Avigilon ALTA - Page 75

AddoneACUorSDC
1. Goto Devices>ACUs.
2.
ToaddanewACUorSDC,clickthe buttonintheupper-rightcorner.
3. EnteranamefortheACUorSDC.
4. InControllertype,selectthetypeused:
l
Firstgeneration-RedBoard(OP-AS-01)—ForfirstgenerationSmartHubs.
l
SingleDoorController(SDC)
l
CoreseriesACU—ForCoreSeriesSmartHubs.
5. IfyourACUorSDCalsoconnectstoanexpansionboard,addtheappropriatetypesinEXPANSION
BOARDS:
l
Openpath4-PortExpansion
l
Openpath8-PortExpansion
l
Openpath16-PortElevator
Tip:ThisconfigurationismostcommonwiththeCoreSeriesSmartHubs.
6. Optional.ToconnectyournetworktotheCloudusingastaticIPaddressandportonanallowlist,select
theEnableStaticCloudIPtoggle.Defaultportis443.
Note:AnEnterpriseplanisrequiredtousearangeofstaticIPaddresses.Inaddition,goto App
marketplaceandensuretheStaticCloudIPappisinstalled.AfterthetoggleisenabledintheControl
Center,opentheOpenAdminappandselectProvisionwithStaticCloudIPtoprovisionthedevices.
7. ClickSave.
Devices 75