Avigilon ALTA - Page 81

l
PowerFailureMode—Howthelockbehaveswhenthebatteryfails.

o
AsIs-Lockremainsinthesamestate.

o
Safe-Lockisunlocked.

o
Secure-Lockislocked.
l
BeeperEnabled—Beepingisemittedfromthelockwhenacredentialisscanned.
l
InvalidCardAudit—Logsinvalidcredentials.
3. InREADERSETTINGS,setthetypeofcardandfobcredentialssupportedbythelock.
l
ForOpenpathDESFireEV1,EV2,andEV3select14443UID(CSN).
l
ForOpenpathDESFireEV3-A,select14443SecureMifare.
Note:Youcannotenable14443UID(CSN)and14443SecureMifare/MifarePlus/EV1(NOC)at
thesametime.
4. UnderMobileCredential,choosewhethertoenablemobilecredentialsonthislock.
a. AdjustCommunicationRangetodeterminehowclosethemobilecredentialneedstobetothe
lockbeforeappearingasanearbyentryintheapp.
b. AdjustPerformancetodeterminehowoftenthemobileappscansforlocks.
5. ClickSave.
ConfigureControllocks
1. FromWirelesslocks,selectthelock.
2. UnderBasicSettings,youcandothefollowing:
a. EnableordisabletheBeeperonthelockwhenacredentialisscanned.
b. EnableordisabletheInvalidCardAudit,whichlogsinvalidcredentials.
3. ReaderSettingscannotbeeditedonControllocks;highfrequencycardsandfobsareenabledbydefault.
4. UnderMobileCredential,choosewhethertoenablemobilecredentialsonthislock.
5. AdjustCommunicationRangetodeterminehowclosethemobilecredentialneedstobetothelock
81