AvMap EKP-IV - 6.6 REVERSE A FLIGHT PLAN; 6.7 GOTO FLIGHT PLANS

48
User Manual
6.6 REVERSE A FLIGHT PLAN
The Flight Plans stored in the EKP-IV memory can be automatically reversed
by:
>‘MENU’ 1 sec. + “FLIGHT PLAN” + ‘ENTER’ + ‘MENU’ + “REVERSE FP” + ‘ENTER’
The message “DONE” will appear to the right of the menu selection and the
sequence of the Waypoints change immediately on the screen.
6.7 GOTO FLIGHT PLANS
A GoTo Flight Plan is a one leg direct Flight Plan to a specified Database
object or cursor position on the Moving Map.
6.7.1 GOTO - DATABASE MODE
To activate a GoTo Flight Plan within a Database page (see Chapter 8) press
‘GOTO’. Doing this will deactivate the current Flight Plan and redraw the
screen to the Moving Map page. All navigation information is now related to
this object.
To Deactivate the GoTo Flight Plan, from the Moving Map screen press
‘GOTO’. A GoTo Menu box will appear with the option to deactivate. Press-
ing “DEACTIVATE FP” will cancel the navigation data and place the EKP-
IV in a Plotter Mode without an active Flight Plan.
If a Flight Plan was active prior to the GOTO, the Flight Plan will resume as
active.
6.7.2 GOTO - MOVING MAP MODE
To activate a GoTo Flight Plan from the Moving Map, press ‘GOTO’. A
“GoTo” Menu box will appear on the screen. You can select the current cursor
position or select a Database object category. When selecting the Database
category, the Database menu will appear (see Chapter 8 for details on search-
ing the Database Menu). Once the desired object has been found, press ‘GOTO’
to activate.
NOTE
‘GOTO’ creates a temporary Flight Plan that is not stored in the EKP-IV memory.