85User Manual
14.5.1 DISTANCE UNIT
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “UNITS SETUP” + ‘ENTER’ + “DISTANCE” +
‘ENTER’
Distance measurements can be displayed in Statute Miles (SM), Nautical Miles
(NM) or kilometers (KM). The default setting is NM.
14.5.2 SPEED UNITS
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “UNITS SETUP” + ‘ENTER’ + “SPEED” +
‘ENTER’
Speed measurements can be displayed in miles per hour (MPH), Knots (KTS)
or kilometers per hour (KMH). The default setting is Knots.
14.5.3 ALTITUDE UNIT
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “UNITS SETUP” + ‘ENTER’ + “ALTITUDE” +
‘ENTER’
Altitude measurements can be displayed in Feet (FT), Meters (MT) or Flight
Levels (FL). The default setting is Feet.
14.5.4 DEPTH UNIT
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “UNITS SETUP” + ‘ENTER’ + “DEPTH” +
‘ENTER’
Depth measurements can be displayed in Feet (FT), Fathoms (FM) or Meters
(MT). The default setting is Feet.
14.5.5 FUEL UNIT
Fuel units are used in the Fuel Consumption Calculator.
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “UNITS SETUP” + ‘ENTER’ + “FUEL” + ‘EN-
TER’
You may select Gallons (GAL), Liters (LIT), Kilograms (KG), Pounds (LB) or
British Gallons (BGAL). The default setting is Gallons.
14.5.6 DESCENT RATE
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “UNITS SETUP” + ‘ENTER’ + “DESCENT
RATE” + ‘ENTER’
The Descent Rate is used in the Vertical Navigation calculation. It can be dis-
played as Feet per Minute (FT/MIN) or Meters per second (M/S) or Degrees
(DEG). The default setting is Feet per Minute.
14.5.7 TEMPERATURE
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “UNITS SETUP” + ‘ENTER’ + “TEMPERA-
TURE” + ‘ENTER’
The Temperature is used in the Wind Calculation. You may select Fahrenheit
(F) or Celsius (C). The default setting is Celsius.
To Next Page
Loading...
