USER INTERFACE
10
3. USER INTERFACE
3.1 Local Access
Connect your USB mouse to one of the USB ports on the front panel, and check if there’s a mouse icon ( ) on the
screen, indicating the USB mouse is detected properly.
Move your mouse to enter the password with the password keypad. The default user name and password are both
“admin”. The status will be changed from (key lock) to (unlock).
Note: You may configure four different user levels to have different access privileges in “SYSTEM”
“ACCOUNT”. For details, please refer to “4.3 User Level Creation” at page 13.
Password Input
3.2 Local
3.2.1 Device Status
Note: The functions shown may vary based on the model or the access user level you use.
Key lock
Key unlock
Channel lock
Channel unlock
USB flash drive / device connected
No USB device connected
Timer record on
Timer record off
Overwrite on
Overwrite off
Sequence mode on
Sequence mode off
PTZ mode on
PTZ mode off
Backup event queued and USB flash drive needed
USB flash drive full
CPU loading
Network Status:
(WAN) Internet connected
(WAN) Internet disconnected
(WAN) Local connection
(LAN) Auto mode –Mbit/s
(LAN) Auto mode – Gbit/s
(LAN) DHCP / Static IP mode
(LAN) Camera disconnected
3.2.2 Channel Status
Note: The functions shown may vary based on the model or the access user level you use.
Auto search on
Auto search off
Original size Fit to screen
Live audio on
Audio off
Audio playback on
Audio playback off
Recording
PTZ control Alarm event Motion event
Live information
Playback information
Digital zoom Channel Playback
Quick camera control
To Next Page
Loading...
Need help?
General
