MAIN MENU
25
5.4 ADVANCED CONFIG
5.4.1 CONNECTION
To manually assign the address of your camera connected locally, click “URI” to modify.
ADVANCED CONFIG
CONNECTION CHANNEL URI CONFIG
CAMERA
CH1 AVTECH://ip_office.ddns.eagleeyes.tw:80 SETUP
DETECTION
CH2 ONVIF://10.1.1.14:88 SETUP
ALERT
CH3 AVTECH://10.1.1.30:88 SETUP
NETWORK
CH4 AVTECH://10.1.1.12:88 SETUP
DISPLAY
RECORD
EXIT
Then, click “SETUP” to enter the access information of the camera:
CONFIG-CH1
CACHE TIME (MSEC)
VENDOR AVTECH
DEVICE IPCAM(FIXED)
PROFILE PROFILE-3
TYPE H264
IMAGE SIZE 720 X 480
QUALITY
I.P.S. 30
AUDIO ON
RESOLUTION LIST Select All
EXIT
Step1: Click “DEVICE” to detect and make sure the access information you’re intended to connect is correct.
Step2: Select the image size, image quality, and I.P.S.
Note: The options selectable for “IMAGE SIZE” and “I.P.S.” depends on the camera you’re intended to
connect.
Note: The “IMAGE SIZE” options for 8CH model is up to 1280 x 720.
Step3: (Optional) For the camera with audio recording, select “ON” or “OFF”.
Step4: (For selected models only) Assign the resolution you could choose based on you need. This change will
affect the resolution options you could choose for live viewing and recording.
To Next Page
Loading...
Need help?
General
