Avtech AVH304 - Appendix 5: Setting Push Video; A5.1 Prerequisites for Push Video

APPENDIX 5 SET PUSH VIDEO
39
APPENDIX 5 SET PUSH VIDEO
Note: Available only when your recorder supports Push Video.
This series supports instant event notifications to your iOS
®
/ Android™ mobile device with our self-developed
program, “EagleEyes”, installed when it's used with the ETS IP camera series.
A5.1 Prerequisite
Before setting this function, make sure you have checked the following:
 You have an iPhone
®
/ iPad
®
/ Android™ mobile device with our self-developed program, “EagleEyes”, installed. For
details, please refer to the previous chapter.
 An ETS IP camera is connected to this recorder, and this camera has built-in an alarm sensor, or an alarm device, such
as magnetic contacts, is connected to this camera.
 The alarm configuration is set properly in “ADVANCED CONFIG” .
 “NOTIFY”  "PUSH VIDEO”, and "GUARD"
is set to “ON”.
Note: For details, please refer to “PUSH VIDEO (for selected models only)” at page 31.
 The recorder is connected to Internet. For details, please refer to
www.surveillance-download.com/user/network_setup/network_setup_recorder.pdf.