NETWORK
BRIGHTNESS 128
DISPLAY
CONTRAST 128
RECORD
SATURATION 128
NOTIFY
CH COVERT IN SUPERVISOR MODE ON
EXIT
1) FULL SCREEN DURATION
Select the full screen dwell duration time in second (03 / 05 / 10 / 15).
2) QUAD SCREEN DURATION (For selected models only)
Select the quad screen dwell duration time in second (03 / 05 / 10 / 15).
3) DISPLAY COVERT
Select “ON” or “OFF” to display or hide the wording “COV.” when covert recording is activated in “CAMERA”.
4) HDD DISPLAY MODE
Select “REMAINING SIZE” to show the remaining HDD capacity for recording in GB, or “REMAINING TIME”
to show the remaining recording time.
5) BRIGHTNESS / CONTRAST / SATURATION
Click the current value to manually adjust the brightness/contrast/saturation/ of the screen.
5.4.7 RECORD
Note: Please DO NOT change the date or time of your recorder after the recording function is activated.
Otherwise, the recorded data will be disordered and you will not be able to find the recorded file
to backup by time search. If users change the date or time accidentally when the recording
function is activated, it’s recommended to clear all hard disk data, and start recording again.
ADVANCED CONFIG
CONNECTION
MANUAL RECORD OFF
CAMERA
EVENT RECORD ON
DETECTION
TIMER RECORD OFF
ALERT
PRE-ALARM RECORD ON
NETWORK
OVERWRITE ON
DISPLAY
KEEP DATA LIMIT (DAYS) OFF
RECORD
RECORD CONFIG SETUP
NOTIFY
EXIT
1) MANUAL RECORD
Set the manual recording function on / off.
2) EVENT RECORD
Set the event recording function on / off.
3) TIMER RECORD
Set the timer recording function on / off.
To Next Page
Loading...
Need help?
General
