FOR INITIAL USE
9
SETUP WIZARD
DDNS ON
SYSTEM NAME Eagleeyes
HOST NAME MAC000E533A3D
E-MAIL
CURRENT HOST ADDRESS
MAC000E533A3D4A.ddns.eagleeyes.tw
SKIP
PREV NEXT
Enable DDNS if needed.
Note: To enable the DDNS later, please go to MENU NETWORK DDNS.
3.2 Mount / Unmount Hard Disk
Power on your recorder and wait till the initialization is completed. Then, check the hard disk indicators on the
front panel to make sure each hard disk installed is detected.
Right click the mouse to exit from the full screen mode. Click MENU → STORAGE to see if all hard disks you
inserted are detected, and click
one by one to mount them. Wait till the hard disk is mounted and the status
shows READY. When you’re prompted to clear the hard disk, choose YES.
To unmount the hard disk, click
to unmount, and the status will turn from READY to INACTIVE.
STORAGE
HDD NEARLY FULL (GB) 5
HDD OVERHEAT ALERT (°C) 70
OVERWRITE ON
KEEP DATA LIMIT(DAYS) OFF
TEMPERATURE TO ENABLE FAN 30
REMINDER WHEN FORMATTING HDD OFF
ID TYPE STATUS SIZE TEMP. SERIAL NUMBER FREE SIZE FORMAT TIME HEALTH STATUS
HDD 5-1 NORMAL INACTIVE 750GB -- WD-WCAV53797317 269.856GB 2017/07/18 23:03:52 GOOD
HDD 5-2 NORMAL READY 1.00TB -- WD-WMC1U5344933 9.88GB 2017/07/18 23:10:55 GOOD
3.3 Change User Name and Password
It’s highly recommended to change the user name and password of this device to keep your account safe.
Otherwise, any person could access this device if he knows the default user name and password.
If you didn’t go through the setting wizard at the first place, you’ll be prompted to change the user name and
password:
WARNING
PLEASE BE ADVISED TO MODIFY THE DEFAULT
ACCOUNT TO ENSURE YOUR INFORMATION SECUIRTY.
MODIFY
O REMIND ME LATER
O DON’T REMIND ME ANYMORE
CONFIRM
Choose MODIFY to start the change immediately.
To Next Page
Loading...
Need help?
General
