FREQUENTLY-USED FUNCTIONS
16
5. FREQUENTLY-USED FUNCTIONS
5.1 IP Device Search
On the recorder’s live view, choose MENU
CAMERA CONNECTION to go to the setting page. For the
channel to which you want to connect the IP camera, change the interface from COAXIAL to IPCAM.
CONNECTION
CHANNEL
TITLE
INTERFACE EDIT ENABLE URI PORT DEVICE
TYPE
VENDOR MODEL STREAM
PROTOCOL
METHOD PATH1 PATH2
CH1 IPCAM
192.168.1.11 88 IPCAM AVTECH RTP-Unicast TCP
CH2 IPCAM
CH3 COAXIAL
CH4 COAXIAL
IP SEARCH
Choose IP SEARCH to go to the IP SEARCH page directly and start searching the connected IP cameras.
You’ll see the list of every connected IP camera with its connection status to this device and MAC address. Click
to assign the camera to the channel automatically and choose ADD to complete.
IP SEARCH
ASSIGN EDIT DEVICE TYPE IP NETMASK GATEWAY PRIMARY DNS PORT MAC VENDOR
CH1
IPCAM 192.168.1.11 255.255.255.0 192.168.1.1 8.8.8.8 88 00:0E:53:31:06:E5 AVTECH
IPCAM 192.168.1.11 255.255.255.0 0.0.0.0 8.8.8.8 88 00:0E:53:31:06:E5 ONVIF
IPCAM 192.168.1.12 255.255.255.0 192.168.1.1 8.8.8.8 88 00:0E:53:31:15:D1 AVTECH
IPCAM 192.168.1.12 255.255.255.0 0.0.0.0 8.8.8.8 88 00:0E:53:31:15:D1 ONVIF
REFRESH ADD
Make sure the IP address of the connected camera is in the network segment the same as your router uses.
If not:
For our brand’s IP camera, select
and change the network type from STATIC to DHCP. Then, click
APPLY to save your changes.
SETUP
NETWORK TYPE DHCP
IP 192.168.1.11
PORT 88
USER NAME admin
PASSWORD *****
NETMASK 255.255.255.0
GATEWAY 192.168.1.1
PRIMARY DNS 8.8.8.8
CANCEL APPLY
For other brand’s IP camera, please check its user manual to manually change its IP address.
To Next Page
Loading...
