MAIN MENU
50
Step1: Save the upgrade files obtained from your installer or distributor in a compatible USB flash drive, and
insert it into the USB port.
Step2: Choose
to browse to where the firmware file is saved and choose the file to upgrade. Then, choose
SELECT to confirm and return to the upgrade page.
/ USB DEVICE
NAME SIZE TYPE MODIFIED DATE
FullImg-1086-1033-1046-1020.bin 27.6MB regular file
2017-07-13 12:19:32
FullImg-1022-1007-1011-1009.bin 9.6MB regular file
2017-08-16 17:05:16
CANCEL SELECT
Step3: Repeat Step2 as many as needed until all cameras which need firmware upgrade are selected.
If one firmware file applies to several IP cameras, select COPY TO to apply the same file to the
applicable cameras.
Step4: Choose UPGRADE to start upgrading all selected cameras, or choose
to upgrade the camera one
by one.
6.12.3 ALERT
ALERT
EXT. ALERT OFF
INT. BUZZER ON
KEY BUZZER ON
VLOSS BUZZER ON
MOTION BUZZER ON
ALARM BUZZER ON
HDD BUZZER ON
ALARM BUZZER DURATION (SEC) 10
1) EXT. ALERT
Select to enable or disable the sound when any external alarm is triggered (ON / OFF).
2) INT. BUZZER
Select to enable or disable the sound (ON / OFF) for all internal buzzers: KEY BUZZER, VLOSS
BUZZER, MOTION BUZZER, ALARM BUZZER, and HDD BUZZER.
Note: When this item is set to OFF, item 3) to item 7) will be disabled even though they are set to ON.
3) KEY BUZZER
Select to enable or disable the sound when pressing the buttons on the front panel (ON / OFF).
4) VLOSS BUZZER
Select to enable or disable the sound when video loss happened (ON / OFF).
5) MOTION BUZZER
Select to enable or disable the sound when any motion alarm is triggered (ON / OFF).
6) ALARM BUZZER
Select to enable or disable the sound when any internal alarm is triggered (ON / OFF).
7) HDD BUZZER
Select to enable or disable the sound (ON / OFF) when the HDD remaining capacity reaches to the value
set in HDD NEARLY FULL (GB).
8) ALARM BUZZER DURATION (SEC)
Select the duration time for alarm buzzer in second (5 / 10 / 20 / 40).
To Next Page
Loading...
