MAIN MENU
26
6.1.5 ALARM OUT
Note: An alarm-out device (such as a buzzer) should be connected to a camera first for this function to
take effects. To configure the alarm-out device connected to the recorder itself, please refer to
“6.11.4 LOCAL ALARM OUT” at page 47.
This function is used when the external alarm-out device is connected to a camera. You can configure an
alarm-out device to activate continuously or activate only for a period of time when it’s triggered.
In RESTORE AUTOMATICALLY,
Choose DISABLE to allow the device to activate continuously when it’s triggered unless you switch it off manually
from the alarm-out switch control panel (
) on the live view.
Choose ENABLE to allow the device to activate only for a period of time (1 / 3 / 5 / 10 / 20 / 30 / 60 / 120 / 180
seconds) when it’s triggered.
ALARM OUT
CHANNEL TITLE NAME RESTORE AUTOMATICALLY ALARM OUT DURATION (SECS)
CH1 alarmout-ch1 DISABLE 1
CH2 alarmout-ch2 ENABLE 5
CH3
CH4
APPLY
6.2 RECORD
Set the image size, video quality and other related parameters individually for live display, record streaming and
sub streaming.
Note: The settings shown below depend on the setting tab you selected in this setting page.
a) D.O.R (Depend on record): When this option is checked, the video size, quality and other related
parameters will follow the configurations in RECORD STREAM.
b) PROFILE: Select the video profile pre-defined in your IP cameras. You can directly use the profile setting,
or modify the setting on this page.
c) TYPE: Select the compression format for each channel.
Note: The options selectable for TYPE depend on the camera you’re intended to connect.
d) IMAGE SIZE: Select the image size for each channel.
Note: The options selectable for IMAGE SIZE depend on the camera you’re intended to connect.
e) QUALITY: Select the video quality for each channel. The higher the value, the better the image quality.
f) I.P.S.: Image per Second, the higher the value, the more fluent the video.
Note: The options selectable for “I.P.S.” depends on the camera you’re intended to connect.
g) BITRATE (kbps): Select how much data to process per unit of time for each channel. The higher the
value, the better the video quality.
h) BITRATE CONTROL: Configure the upper bit rate limit for the selected channel if necessary.
VBR - When the bit rate of the camera exceeds the value you set, the video fluency may be affected;
CBR - When the bit rate of the camera exceeds the value you set, the image quality may be affected.
i) G.O .V.: “Group of VOPs” is used to configure the length of G.O.V. The greater of the value, the less the
bandwidth for transmission, and the poorer the image quality.
To Next Page
Loading...
