MAIN MENU
44
Note: You may receive NTP-based DDoS attacks when this function is enabled. Please make sure your
network is secured to prevent this kind of attack.
6.9.2 DAYLIGHT
DAYLIGHT
DAYLIGHT SAVING ON
START TIME 1ST
MON
AUG
06:00
END TIME LAST
MON
OCT
10:00
ADJUST 01:00
Depending on the time zone you’re in:
1) DAYLIGHT SAVING
Select to enable (ON) or disable (OFF) this function.
2) START TIME / END TIME
Set the start time and end time.
3) ADJUST
Set the time in HOUR : MIN.
6.10 DISPLAY
DISPLAY
CHANNEL TITLE ON
EVENT STATUS ON
AUTO KEY LOCK(S) 30
HDD DISPLAY MODE RE,MAINING SIZE
DISPLAY OUTPUT AUTO
LANGUAGE ENGLISH
SPOT MONITOR SETUP
CALL SCREEN DURATION 03
QUAD SCREEN DURATION 03
1) CHANNEL TITLE
Select to display the channel title or not (ON / OFF).
2) EVENT STATUS
Select to display the event icons or not (ON / OFF).
Note: For details about each event icon, please refer to “4.3 Status & Operation” at page 12.
3) AUTO KEY LOCK(S)
Set the time-out in second after which the key lock function is activated (NEVER / 30 / 60 / 120).
4) HDD DISPLAY MODE
Select REMAINING SIZE to show the remaining HDD capacity for recording in GB, or REMAINING
TIME to show the remaining recording time.
5) DISPLAY OUTPUT
Select the display resolution you want. The default value is AUTO. This is used for the main display output.
Note: To have the best image quality on your monitor, make sure (1) the selected output resolution is
supported by your monitor, and (2) the output settings on both the LCD monitor and the recorder
are consistent.
If the image is not positioned or scaled properly, please go to your monitor’s menu for
adjustment. For details, please refer to the user manual of your monitor.
To Next Page
Loading...
Need help?
General
