3-6
● Socket mount type (C15S)
Items to be prepared:
Phillips-head screwdriver
The above Figure shows the DIN rail mounting.
(1) Mount the socket inside the panel. (For screw tightening, mount the socket
directly.)
(2) Perform the wiring to the socket.
(3) Push this unit into the socket.
(4) Put the upper and lower socket stoppers in the stopper holes in the main body,
and then insert them.
Handling Precautions
For socket mount type, it is necessary that the wiring must be
completed before mounting this unit on the socket.
Chapter 3. INSTALLATION
To Next Page
Loading...
Need help?
General
