Azbil SDC15 - rE-1 (Manual reset) setup

6-11
■ Communication DI (digital input) 1 setup
(1) In the operation display mode, keep the [para] key
pressed for 2 sec. or longer.
>> The unit then enters the parameter setting mode.
(2) Press the [para] key several times.
>> Display the parameter setting [C.dI1:
Communication DI 1] is displayed.
(3) Press the [], or []key to set the value you have
selected from the following in [C.dI1].
dI.oF: Communication dI1 OFF
dI.on: Communication dI1 ON
>> When no keys are pressed for 2 sec. or longer, the flashing of the numeric
value is stopped to set the currently displayed value.
(4) Press the [mode] key.
>> The display is returned to the operation display.
<
<
Chapter 6. SETTINGS DURING OPERATION
rdy
man
ev1 ev2 ev3 ot1 ot2
para
mode
pv
sp
rdy
man
ev1 ev2 ev3 ot1 ot2
para
mode
pv
sp