ORION Classic Endpoints
ORI-UM-00025-EN-19
ORION CLASSIC ENDPOINTS
This section includes configuration, encoder compatibility and
installation information for ORION Classic (CE) endpoints.
The serial number is engraved on the endpoint body. Serial
numbers range from 70000000 to 89999999.
Endpoint Congurations
The following configuration options are available.
Figure 7: ORION Classic (CE) Endpoint
Endpoint Configurations Encoder Connection
Endpoint only with in-line connector
(Twist Tight, Nicor, 308)
Connect the endpoint to an encoder using the in-line connector.
See "In-line Connectors" on page 29.
Endpoint only with flying lead for field splice See Field Wiring, Encoder Connectivity and Read Resolution
.
Endpoint/encoder assembly with
in-line connector
Factory prewired endpoints, connected to a Badger Meter encoder, are shipped, ready
for installation. No splicing required. See "Endpoint Installation Kits" on page 13.
Prewired integral endpoint/encoder assembly
Mount the assembly on the bayonet of the meter. See "Integral Endpoint Installation" on
page 23 for details.
Field Wiring, Encoder Connectivity and Read Resolution
ORION CE endpoints with flying leads are shipped from the factory pre-programmed. Connect all three wires to an encoder
to complete installation. The endpoint connection can be made to existing wires from the encoder or directly to the encoder
terminal screws, depending on the application and manufacturer. Endpoints can be connected to Badger Meter high
resolution encoders and E-Series Ultrasonic meters as well as a number of competitive encoders as shown in the wiring chart
on the next page.
OTE:N For instructions on field wiring using gel connectors, see "Using Gel Caps to Connect an Encoder" on page 31.
Page 9 February 2019
To Next Page
Loading...
Need help?
General
