Barco E192HSA User Manual

5. Advanced operation
The automatic picture adjustment is activated: the phase and clock per line parameters are automati-
cally adjusted.
5.2.5 Phase
This menu item is only available when VGA input i s connected.
About phase
If the result of the Auto Adjustment procedure described above isn’t satisfactory, the Phase can be man-
ually adjusted by following this procedure.
To manually adjust the phase
1. Bring up the OSD main menu.
2. Navigate to the Picture advanced menu.
3. Enter the Phase submenu.
The command bar Phase is highlighted.
4. Set the phase as desired and confirm.
5.2.6 Clock/Line
This menu item is only available when VGA input i s connected.
About clock/line
If the result of the Auto Adjustment procedure described above isn’t satisfactory, the Clock/Line can be
manually adjusted by following this procedure.
To manually adjust the phase
1. Bring up the OSD main menu.
2. Navigate to the Picture advanced menu.
3. Enter the Clock/Line submenu.
The command bar Clock/Line is highlighted.
4. Set the clock/line as desired and confirm.
5.3 D isplay Format menu
Overview
• Main Source (Primary Source)
• Component Mode
• Zoom
•ImageSize
•2
nd
Picture Mode
•2
nd
Picture Source
•2
nd
Picture Position
K5902113 (451920611383) E192HSA 27/11/2017
25

Barco E192HSA Specifications

General

Brand	Barco
Model	E192HSA
Category	Monitor
Language	English