6. Important information
6.5 Clean ing and disinfectio n
Instructions
• Be sure to unplug the power cord from the mains when cleaning your LCD monitor.
• Take care not to scratch the front surface with any hard or abrasive material.
•Dust,finger marks, grease etc. can be removed with a soft damp cloth (a small amount of mild deter-
gentcanbeusedonthedampcloth).
• Wipeoffwaterdropimmediately.
Possible cleaning solutions
• 250 ppm chlorine solution
• NaCI solution 0.9% – Sodim chloride 00-236
• Bacillol AF
• 1.6 percent aqueous ammonia
• Cidex® (2.4 percent glutaraldehyde solution)
• Sodium hypochlorite (bleach) 10 percent
• “Green soap” (USP)
• Like Cleansafe® optical cleaning liquid
• Isopropanol
• Haemosol solution (1% in 1 liter water)
• Chlorehexidine 0,5% in 70% Ethanol
6.6 Explanation of sym bo ls
Symbols on the device
On the device or power supply, you may find the following symbols (nonrestrictive list):
Indicates the device meets the requirements of the applicable EC directives.
Indicates compliance with Part 15 of the FCC rules (Class A or Class B)
Indicates the device is approved according to the UL Recognition regulat
ions
Indicates the device is approved according to the UL regulations for Canada
and US
Indicates the device is approved according to the UL Demko regulations
Indicates the device is approved according to the CCC regulations
K5902113 (451920611383) E192HSA 27/11/2017
41
To Next Page
Loading...
