11. Lamp menu
These parameters are useful when calling for a service intervention.
How to display?
1. Press MENU to activate the menus.
2. Use the ▲ or ▼ key to select Lamp and press ENTER.
3. Use the ▲ or ▼ key to select Identification and press ENTER.
The identification overview is displayed.
Image 11-16
Image 11-17
Image 11-18
11.7 Z-axis adjustment
What can be done?
This menu item gives the current light output of the projector. This light output indication can be used to readjust the lamp position in
the lamp casing (also called Z-axis adjustment of the lamp). With higher run times, the light output of the lamp will decrease, which
results in a lower light output on the screen. This light output decrease can be compensated by readjusting the position of the lamp.
For the realignment procedure, see "Realignment of the lamp in its reflector", page 191.
How to display the light output
1. Press MENU to activate the menus.
2. Use the ▲ or ▼ key to select Lamp and press ENTER.
3. Use the ▲ or ▼ key to select Z-axis and press ENTER.
The Z-axis dialog box is display and indicates the current light output..
Image 11-19
Image 11-20
Image 11-21
R59770179 FLM R22+ 15/03/2010 115
To Next Page
Loading...
