9. Image menu
How to start up?
1. Press MENU to activate the menus.
2. Use the ▲ or ▼ key to select Image and press ENTER.
3. Use the ▲ or ▼ key to select Timings and press ENTER.
The timings menu will be displayed.
Image 9-62
Image 9-63
Image 9-64
4. To change a setting, use the ▲ or ▼ key to select and press ENTER.
The corresponding adjustment box is displayed. E.g. Horizontal total pixels.
Image 9-65
5. Use the ▲ or ▼ key (or ◄ or ► key) to change the value.
6. Press ENTER to activate the new value.
7. If necessary to change other settings, repeat from step 4.
9.5.2 Advanced settings
About the advanced settings
Clamp delay The time between the leading edge of the clamp pulse and the locked edge of the sync pulse. Can be
any value between 0 and 255.
Clamp width The width of the clamp pulse can be any value between 0 and 255.
84
R59770179 FLM R22+ 15/03/2010
To Next Page
Loading...
