16. Servicing
Image 16-9
4. Push the input & communication unit forward until you feel the connectors of the unit
fit in their sockets. The back of the front
plate of the unit must touch the chassis of the projector.
5. Secure the input & communication unit by fastening the four captive screws in the corners of the unit.
Image 16-10
16.6 Installation of an input module
The procedure below is applicable to all input modules of the input & communication unit of the projector.
Necessary tools
Phillips screw driver PH1.
How to install an input module into the input & communication unit of the projector ?
1. Switch off the projector and unplug the power cord at the projector side.
2. Slide the input module into the guides of the input slot.
190
R59770179 FLM R22+ 15/03/2010
To Next Page
Loading...
