Barco FLM R22+ - Realignment of the lamp in its reflector

16. Servicing
Image 16-4
16.3 Removal of an input module
The procedure below is applicable to all input modules of the input & communication unit of the projector.
Necessary tools
Phillips screw driver PH1.
How to remove an input module out of the input & communication unit of the projector ?
1. Switch off the projector and unplug the power cord at the pr
ojector side.
2. Release the two captive screws of the input module using a Phillips screw driver PH1.
Image 16-5
3. Pull the input module out of the input & communication unit, via the two knobs provided.
R59770179 FLM R22+ 15/03/2010
187