13. Projector control
Level 1 Level 2 Level 3
Shortcut keys
Menu position
Menu
Bar scale
Local LCD
Local LCD time out
Local LCD contrast
Language
English
Français
Deutsch
Español
Italiano
13.2 Projector address
Overview
• Individual projector address
• Common address
13.2.1 Individual projector address
About individual projector address
Before a projector, and only this projector, can be controlled via a remote control, an individual address must be entered in the
projector.
This individual projector address can then be used to control the projector via remote control or via a serial connection.
Next to an individual projector address, each projector has also a common address for group control.
How to set an individual address?
1. Press MENU to activate the menus.
2. Use the ▲ or ▼ key to select Projector control and press ENTER.
3. Use the ▲ or ▼ key to select Projector address and p
ress ENTER.
4. Use the ▲ or ▼ key to select Projector Address and press ENTER.
The edit projector address window opens.
5. Use the ▲ or ▼ key to select a new value
Or,
enter a new value with the digit keys on the remote control or local keypad.
6. Use the ◄ or ► key to select the next digit and repeat step 5.
7. When the desired address is entered, press ENTER to store that address.
146
R59770179 FLM R22+ 15/03/2010
To Next Page
Loading...
