13. Projector control
Image 13-29
Image 13-30
Image 13-31
Image 13-32
6. Press EXIT to return.
13.5 IR control switching
What can be done?
Each IR receiver inside the projector can be activated or deactivated. When an IR receiver is deactivated, no IR signal send to this
IR receiver will be processed.
How to switch
1. Press MENU to activate the menus.
2. Use the ▲ or ▼ key to select Projector control and press ENTER.
3. Use the ▲ or ▼ key to select IR Control and press ENTER.
4. Use the ▲ or ▼ key to select the desired IR receiver and press ENTER to toggle this receiver [on] or [off].
Image 13-33
Image 13-34
Image 13-35
13.6 Art-Net DMX
DMX
DMX-512 Lighting protocol, here used over Ethernet. Carries information of 512 channels from a lighting controller to
lighting devices. Standardized by USITT.
R59770179 FLM R22+ 15/03/2010 153
To Next Page
Loading...
