Barco MDSC-8231 - 5.4.4 Recall Profile; 5.4.5 Save Profile; 5.5 System menu; 5.5.1 Power on DVI

R5911692 /01 MDSC-823140
• 60 Sec.
• Disabled (=5 minutes)
To adjust the OSD time-out
1. Bring up the OSD main menu.
2. Navigate to the Configuration menu.
3. Enter the OSD setting submenu.
4. Select OSD Time-out
5. Select one of the available OSD time-out values and confirm.
5.4.4 Recall Profile
About recalling profiles
To recall a profile means to restore the default factory settings (Factory and X Ray profiles) or recall the user
defined profiles.
The available profiles to recall from your display are:
• Factory
• X Ray
• User 1
• User 2
• User 3
To recall a profile
1. Bring up the OSD main menu.
2. Navigate to the Configuration menu.
3. Enter the Recall Profile submenu.
4. Select one of the available profiles to recall and confirm.
5.4.5 Save Profile
About saving profiles
The user can modify the default video parameters associated to each profile and save the new parameter
settings under the User 1, User 2 or User 3 profile. The Factory and X Ray profiles can be modified, but the
factory default can’t be overwritten and can always be recalled through the recall profile menu item.
The available profiles to save in your display are:
• User 1
• User 2
• User 3
To save a profile
1. Bring up the OSD main menu.
2. Navigate to the Configuration menu.
3. Enter the Save Profile submenu.
4. Select one of the available profiles to save and confirm.
5.5 System menu
5.5.1 Power on DVI
About power on DVI
This setting allows you to select the pin of the DVI connector on which the +5V DC supply is applied.
Advanced operation