R5911692 /01 MDSC-823146
7.1 Safety information
General recommendations
Read the safety and operating instructions before operating the device.
Retain safety and operating instructions for future reference.
Adhere to all warnings on the device and in the operating instructions manual.
Follow all instructions for operation and use.
Electrical Shock or Fire Hazard
To prevent electric shock or fire hazard, do not remove cover.
No serviceable parts inside. Refer servicing to qualified personnel.
Do not expose this apparatus to rain or moisture.
Modifications to the unit
Do not modify this equipment without authorization of the manufacturer.
Preventive maintenance
Periodic maintenance inspections are essential to keep the monitor in optimum condition and ensure safe
operation.
With the monitor disconnected from the mains, perform the following periodic check:
• Check the integrity of the power cord and inspect its routing, so that it is not under the risk of being
punched or cut.
• Check the integrity of the protective earth connection.
• Clean the area around the power plug. Dust and liquids may result in fire.
• Clean the ventilation slot of the monitor. Dust can obstruct the air flow and cause temperature increase of
the electronics.
General recommendations:
• Keep the monitor clean to prolong its operational lifetime.
• LCD panel performance may deteriorate in the long term. Periodically check that it is correctly operating.
• Periodically check the tightness of the VESA mount screws. If not sufficiently tight, the monitor may detach
from the arm, which may result in injury or equipment damage.
• In case the failover functionality is used, periodically check the OSD menu settings to verify the correct
assignment of main and secondary input (backup) and perform a test to verify the correct activation of the
backup input.
Type of protection (Electrical)
Equipment with external power supply: Class I equipment
Degree of safety (flammable anesthetic mixture):
• Equipment not suitable for use in the presence of a flammable anesthetic mixture with air or with oxygen or
nitrous oxide.
• The equipment shall not be operable when the air oxygen content is above 25%.
Non-patient care equipment
• Equipment primarily for use in a health care facility that is intended for use where contact with a patient is
unlikely (no applied part).
• The equipment shall not be used with life support equipment.
• The user should not touch the equipment, nor its signal input ports (SIP)/signal output ports (SOP) and the
patient at the same time.
Important information
To Next Page
Loading...
Need help?
General
Weight and Dimensions
